How do I calibrate my Innovate LC-1?
Press the Reset Calibration button if you want to reset all calibration data in the LC-1. Pressing the Reset Calibration button will trigger the LC-1 to do a full Heater and Free Air Calibration the next time it is power cycled. Make sure the sensor is not in the exhaust during that procedure.
What is an LC-1?
The LC-1 Lambda cable is a complete wideband controller built in to a sealed cable. It features the same award-winning patented digital measurement principal found in the LM-1 & LM-2, and includes digital input, output, and 2 user programmable analog outputs. (
What is wide band tuning?
In short, a wideband oxygen sensor will give you a measurement of your Air/Fuel Ratio from about 10:1 up to about 20:1 AFR allowing you to target exactly the AFR you’re after at all times.
Who heads a division in Uganda?
A district is led by an elected local council V (LCV) chairperson and his executive. There is also an elected LCV Council, with representatives from the sub-counties and technical staff in the district.
Do O2 sensors need to be calibrated?
A brand new O2 Gas Sensor does not need to be calibrated, but the sensor will drift over time and will need to be calibrated. To calibrate the sensor, follow the normal 2-point calibration procedure. -For the first point, push and hold the calibrate button on the sensor using a paper clip or LabQuest stylus.
Do you need O2 sensors to tune?
The front O2 sensors have no affect on the WOT part of your tune. Only idle and part throttle (closed loop) driving. You can safely swap in a new set and data log your trims and see if the tune is still in check or not.
What is the LC-1 and how does it work?
The LC-1 is also a key component of Innovate Motorsports’ Modular Tuning System (MTS). Using the LC-1’s serial ports you can daisy-chain other Innovate devices such as the XD-16, AuxBox (LMA-3), DL-32, TC-4, and SSI-4. The basic LC-1 kit ($199) includes the LC-1, sensor, bung, and a serial cable to connect to the PC.
What is the LC-2’s technology?
The LC-2’s patented award-winning DirectDigital™ signal processing technology provides data on exactly how rich or lean an engine is running at any load. The LC-2’s self-calibrating circuitry also compensates for changes in temperature, altitude, and sensor condition.
Can I daisy-chain the LC-1 with other innovate devices?
Using the LC-1’s serial ports you can daisy-chain other Innovate devices such as the XD-16, AuxBox (LMA-3), DL-32, TC-4, and SSI-4. The basic LC-1 kit ($199) includes the LC-1, sensor, bung, and a serial cable to connect to the PC.
What is the LC-1 Lambda cable?
The LC-1 Lambda cable is a complete wideband controller built in to a sealed cable. It features the same award-winning patented digital measurement principal found in the LM-1 & LM-2, and includes digital input, output, and 2 user programmable analog outputs. (View Video)