Are all Winchester AA hulls the same?
Winchester advises that the original Win AA and the new Win AA-HS hulls are interchangeable. In the general sense of speed and pressure this may be true. However, there are some fit and finish concerns that require attention and different, accomodating components.
What is a Winchester AA HS Hull?
The NEW Winchester AA hull (referred to as High Strength or “HS” by Winchester) is a three-piece Reifenhauser type design. It consists of a brass head, an inner tapered base resembling a plastic cup and a straight length of extruded plastic tubing.
What wads are Winchester AA hulls?
Ie use the 1 oz wad (waa12sl) for 7/8 load and the 1 1/8 wad (waa12) for 1 oz. claybuster clone wads or downrange clone worked well and were cheaper. for gun club hulls I would use the 7/8 with 7/8 as they are one pc hulls.
Who makes the best shotgun hulls?
Use Good Hulls Winchester AA and Remington STS hulls are the two most common, highest-quality hulls for reloading available today. They have brass heads and durable plastic cases that last for quite a few reloads. You can either buy factory loads and save the hulls or purchase empties from gun clubs or online.
Are Winchester AA hulls compression formed?
The Winchester AA’s used to be a one piece compression formed hull.
Does Kent use Cheddite hulls?
Ward is right, Kent uses Cheddite hulls. They are a straight walled hull, similar to Fiocchi or Federal.
How many times can you reload paper hulls?
Generally speaking, paper hulls can be reloaded twice with target type reloads before they ‘pin hole’. Plastic hulls can go from a couple of times, sometimes, but not always, to as many as five or six before they get both dirty and ragged looking.
Are Cheddite and federal hulls the same?
Cheddite primers are slightly larger in diameter than are the Federal, and every other American made primer. That means a loose fit in the primer pocket, possible gas leakage and possibly a loose primer falling into the action, after firing if you used an American primer and did not tighten the primer pocket.
What hulls do KENT use?
https://www.youtube.com/watch?v=ZWqMyfrS3ic