How do I setup my Swann camera?
How to Connect Your Cameras to the Swann DVR
- With the included Ethernet cable, connect the DVR to an Internet source like a modem or a router.
- Connect the DVR to a monitor.
- Keep some breathing room around the DVR, because it generates heat and needs good air circulation.
Why is my Swann security camera not working?
You should check first that your camera power supply (or supplies) are properly connected to a wall socket or power strip. If you do have the power supply connected to a power strip, try a wall socket just in case the power strip is faulty or is a specialised unit that doesn’t have all the sockets active at all times.
Where is the reset button on my Swann camera?
DVR16-8600 Hard Factory Reset
- Power off the machine, remove the power plug from the back of the unit.
- Take off all case cover screws located on the back and side of the DVR and remove the case.
- There will be a small black button on the motherboard located towards the front panel of the unit, take note of its location.
How do I reset my Swann cameras?
Disconnect the camera from the NVR (or from a PoE switch or a power adapter) to turn it off completely. Press and hold the reset button. While holding down the reset button, plug the camera back to the NVR (or to the PoE switch or a power adapter) and continue holding down the reset for 30 seconds, then release.
Why won’t My Swann camera connect to my phone?
Make sure that the connection is successful by checking your router and ensuring that your Wi-Fi password is correct. If the camera is still having issues connecting to Wi-Fi, reset the router and try again once it’s back up.
How do I connect my Swann to the Internet?
Article Details
- Go to Menu then Network > Wi-Fi.
- Click Scan to see a list of available Wi-Fi.
- Below that, enter your Wi-Fi password.
- The recorder will connect to your Wi-Fi then you need to click OK.
How do I view my Swann cameras online?
Open the PC-DVR-4-Net software and login by clicking the padlock button. Leave the default username and password (SYSTEM – “blank”) and click OK. Now that you’re logged in, click on the “Config” button (looks like a wrench). Click on the “Return” button so that you see your cameras on the screen again.
How to install Swann cameras?
– For NHD-900DE – click HERE – For NHD-876DER, click HERE – For PRO-4KDER – click HERE
How to install Swann home security cameras?
Take your half inch paddle bit, your drill, and your ladder around your house, and drill holes into the soffit where you plan on mounting your cameras. Attach the end of the cable with the female power adapter to one end of your wire pulling rod and poke it through the hole you drilled, the male adapter should be on the outside of your house.
How to set up a Swann security camera system?
– Set schedule you prefer when the DVR will send alerts. – Click on Apply then OK to save the settings. – The image below shows that on Monday, it is set to send alerts the entire day if there is motion because the time is 00:00-24:00 (24hr format).
How to set up Swann security camera network?
– IP Address – a unique value for the recorder’s local (LAN) IP address that matches the router’s IP address scheme as explained above – Subnet Mask – usually 255.255.255.0 – Gateway – the value of the router’s IP address found from running ipconfig (Windows) or ifconfig (Mac)