How do I run a diagnostic test on a Whirlpool Cabrio washer?
Console & Indicator Diagnostic Test Mode
- The washing machine should be in standby (off) mode.
- Press and release the following buttons within 4 seconds.
- if successful “dt” should display on the washing machines indicator.
- Within 5 seconds press “Start” all indicator lights should come on and 88 should be displayed.
How do you reset the control board on a Whirlpool Cabrio washer?
Try the Cabrio Reset Procedure Or you can press PAUSE/CANCEL. Choose a cycle and press START. Then disconnect the Cabrio from power if you see the issue or error come back. Wait five minutes.
How do you troubleshoot a Cabrio washing machine?
Clean all contact areas on the lid and the washer. Try unplugging the washer to allow the control panel to reset. Plug the washer back in and see if the problem resolves. If the door sounds like it is engaging, but doesn’t, it is time to run a diagnostic test.
How do you diagnose washer control and program problems?
How to Diagnose Washing Machine Control and Program Problems
- What You Will Need:
- Switch Off Your Appliance.
- Check 1 – Turning The Machine On.
- Check 2 – Recognise That It Is Filled With Water.
- Check 3 – Heating The Water & Proceed With Wash Cycle.
- Check 4 – Drain The Water & Proceed With Rinse Cycle.
Is there a reset button on a Whirlpool washing machine?
Follow these steps to reset a Whirlpool washing machine: Make sure the power to the washer is turned on at the wall, but keep the Power button on the control off. Hold the Program button down while simultaneously pressing the Water Level button two times. When done correctly, the control panel lights should illuminate.
Where is the reset button on a Whirlpool washer?
There is no Reset Button on your Whirlpool Washer. Luckily, you can reset the washer in several easy steps. If you need to reset your Whirlpool Washer and, since there is no reset button, first unplug the washer. After two minutes, plug the washer back in.
Is there a way to reset a Whirlpool washer?
Turn off the washer on the control panel. Unplug the washer for twenty seconds. Turn on the washer. If the process has worked, your washer will now be reset.
How do you test a cabrio washing machine?
The Cabrio’s cold water valve and the bleach valve open for 10 seconds. If no water flows through the bleach cup go to manual diagnostic mode: Water valves. C3. The Cabrio’s Hot water and fabric softener valves are opened for 10 seconds.
What should I do if my Cabrio washer does not work?
If the basket does not float or disengage, look for the cause of inner wash basket friction. The Cabrio’s cold water valve and the bleach valve open for 10 seconds. If no water flows through the bleach cup go to manual diagnostic mode: Water valves.
How does a cabrio washer work?
Cabrio’s Hot and cold (Warm Water) primary water valves open as well as the detergent and fresh fill valves, then the fresh valve opens until the Cabrio’s basket floats, disengaging from the basket hub. The Cabrio washer will then continue filling through the detergent and fresh valves to the minimum water level.
How do I check if my Cabrio Washer has a fabric softener?
If your washing machine has a fabric softener dispenser and no water flows go to manual diagnostic mode: Water valves. The Cabrio Washer’s hot and cold (Warm Water) primary water valves open as well as the detergent water valve for 10 seconds If no water flows through the detergent cup go to manual diagnostic mode: Water valves