How do I set up APC UPS?

How do I set up APC UPS?

Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.

  1. Apply the port settings to establish the connection.
  2. Press enter 3-5 times to display the username prompt.
  3. Use the default username and password of “apc”.

How do I calibrate APC Smart UPS 3000?

Business Edition – Click on the name of your UPS, then select Diagnostics. Under “Initiate Diagnostics” select “Calibration” from the dropdown and click apply. Network Management Card – From the “Tests” menu select “UPS”. Select “Runtime Calibration” and click “Apply”.

How do I reset my APC Smart UPS 3000?

APC Smart UPS – How to reset / restart

  1. Turn off and unplug UPS from wall.
  2. Press and hold the OFF button again.
  3. You may see a quick flash of the LED’s and you should hear an audible “”click”” from the UPS.
  4. Turn UPS back on.

What is the default IP address for APC UPS?

192.168.2.66
The default IP address is 192.168. 2.66 with a subnet mask of 255.255. 255.0. The default username is admin and the default password is admin01.

How do I set up Smart UPS?

Getting started is easy..

  1. Install your UPS. Install a next-generation Smart-UPS at your business site.
  2. Scan the QR code. Scan the QR Code printed onto your Smart-UPS to automatically begin registration via the web portal.
  3. Register your UPS. Create a Schneider Electric account for your business.

Is APC Smart Connect free?

APC™ SmartConnect is a free cloud-enabling feature that allows you to monitor your UPS online – anytime – anywhere through any internet connected device.

What is UPS calibration test?

This feature is used for calibrating the estimated remaining battery runtime value. In this test, the UPS transfers to battery operation and the batteries are discharged to the low DC warning level.

How do I know if APC is charged?

Just plug it in to a power source and check the read out There is a battery indicator on the read out when you first plug it in the battery is fully charged. You will be able to see it if the power goes out and it has to charge.

How do I troubleshoot APC UPS?

How to Troubleshoot APC Battery Backup

  1. Plug the battery backup into a working electrical outlet.
  2. Reset the circuit breaker on the battery backup.
  3. Determine if the battery backup is charged and providing battery power.
  4. Charge the battery.
  5. Test battery charge.
  6. Replace the battery backup unit.

What is the default IP for APC Network Management Card?

By default, the APC AP9630 NMC (Network Management Card) does not have an IP address assigned. The easiest way to configure an IP address is to log into the UPS’s NMC over a serial port.