How do I change the oscilloscope wave color in Multisim?

How do I change the oscilloscope wave color in Multisim?

Right-click on the wire leading to input channel A and select Segment color from the context menu that appears. The Color dialog box appears. Click on the desired color for the wire and click OK.

Is there an oscilloscope in Multisim?

Multisim 14.2 Help The dual-channel oscilloscope displays the magnitude and frequency variations of electronic signals. It can provide a graph of one or two signals over time, or allow comparison of one waveform to another.

Where is Tektronix oscilloscope in Multisim?

Click on the Tektronix Oscilloscope tool button in the Instruments toolbar and click to place its icon on the workspace.

How do I change colors in Multisim?

Multisim Help

  1. Right-click on the wire and choose Net color or Segment color from the context menu that appears. A color palette appears.
  2. Choose a color and click OK to apply it to the selected item.

How do you find the current waveform on an oscilloscope Multisim?

Complete the following steps to measure the current:

  1. Double-click on the Oscilloscope icon to show its front panel.
  2. Simulate the circuit and observe the output on the Oscilloscope.
  3. Stop or pause the simulation when a trace displays on the Oscilloscope, as shown in the figure below.

How do you make a Multisim canvas bigger?

Multisim comes with standard sheet sizes that you can use for your design….Do the following in the Sheet size box:

  1. Select the desired size from the drop-down list.
  2. Select either Portrait or Landscape for the sheet’s Orientation.
  3. Set the Width and Height in Inches or Centimeters as desired.

What is Channel A and B in Multisim?

A/B >—Click to display input channel A against input channel B. (A is on the y-axis and B is on the x-axis). These settings display frequency and phase shifts, known as Lissajous patterns, or they can display a hysteresis loop.

How do I use the dual-channel oscilloscope?

The dual-channel oscilloscope displays the magnitude and frequency variations of electronic signals. It can provide a graph of one or two signals over time, or allow comparison of one waveform to another. To place the instrument, click the Oscilloscope button in the Instruments toolbar and click to place its icon (shown below) on the workspace.

How to display waveforms on the oscilloscope?

These settings determine the conditions under which a waveform is first displayed on the oscilloscope. Edge —To start displaying the waveform on its positive slope or rising signal, click the Ascending edge button. To start with the negative slope or falling signal, select the D escending edge button.

How do I make the oscilloscope trigger a single pass?

If a flat signal is expected, or if signals are to be displayed as soon as possible, select Auto . Select the Single button to make the oscilloscope trigger a single pass when the trigger level is met. Once the trace gets to the end of the scope face, the trace will not change until you click Single again.

What is an example of an oscilloscope scale setting?

For example, an input AC signal of three volts fills the oscilloscope’s display vertically when the y-axis is set to 1 V/Div. If the Scale setting is increased, the waveform becomes smaller.