How do I clear E107 on DStv?

How do I clear E107 on DStv?

E107 : Your Smartcard and Decoder are not paired. Solution : this error apears only on new decoders , a call to multichoice contact centre or the installer will resolve this .

How do I get rid of error code on DStv?

If the Error code you see on your T.V set is any of these, just relax and follow this step to get it cleared.

  1. Go to www.DSTV.com.
  2. Select the type of Error code that you see on your T.V set, enter your smart card / Serial No, and solve the Captcha.
  3. Click “Reset Device”

How do I fix error code BE1 on DStv?

How To Clear BE1 DStv Error

  1. The decoder must be switched on.
  2. Press the RESET button on the Front Panel.
  3. Wait for the dl to appear on the Front Panel.
  4. In quick succession press the STANDBY, then P-, then GUIDE, then STANDBY on the FrontPanel.

What do I do if my decoder is not scanning?

How To Fix Dstv Decoder Not Powering Up

  1. Turn off the decoder and switch off the power source.
  2. Remove the power cord from the decoder.
  3. Unplug all peripherals plugged in.
  4. After 10minutes, reconnect the power cable and see if the DStv decoder is powering up.

What is error E107?

How do I reset my DStv decoder?

Press the blue “DStv button” on your remote control. Then use the right arrow on the remote control to go to “Settings“. Use the down arrow to go to “System Settings“. Scroll down using the down arrow to select “Reset To Factory Default” then press “OK” on your remote control.

How do you perform the flash erase for 2 tuner HD PVR?

HDPVR – File flash erase process

  1. Reboot the decoder (from power cable or from front panel)
  2. Immediately PRESS AND HOLD the following keys simultaneously: STOP, EXIT, P+
  3. Keep them pressed for quite some time (30-60 seconds) until you see CLEARING FLASH scrolling on the front panel.

How do you fix a faulty LNB cable?

Slide down the cover of the coaxial cable connector’s joint with the LNB output jack, gently pull the cable to ensure that the joint is firm and secure. If the joint is loose, frayed or corroded, you will need to replace the connector and screw it back into the jack.