How do I program my atomic clock?
Press and hold the “REC” button (D) for 3 seconds. The clock will search for the atomic signal. The clockʼs hands will move to the 12:00 position and the atomic signal will be received within 3-12 minutes. Once the atomic signal has been received, the clock will set itself to the correct time.
How do you set a global atomic Radio Controlled Clock?
Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release. Your clock is now an accurate quartz clock until it will find the signal.
Why has my radio controlled clock stopped working?
Check that the power supply is in full working order. Change the current battery for a fresh one and reset your clock. Try rotating the clock. Most radio-controlled clocks have an internal antenna that picks up the signal most effectively when it is facing directly towards or away from Anthorn.
How do you start a radio controlled clock?
Starting the clock Remove the locking pin (S – see illustration) before inserting the battery. Insert a 1.5 V AA battery into the battery compartment of the clock unit. The clock hands will move to 12 o’clock and stop. Your clock will now start trying to pick up the DCF77 radio signal.
How do I reset my digital clock?
How To Reset Your Digital Wall Clock
- To set the time on your clock, you’ll first need to locate your clock’s “setting” button.
- When you see the hour numbers on your clock begin to flash, press and hold the “hour” button to advance the hours.
- Press the “setting” button (“A”) again, and the minutes will flash.
How do I manually set my LaCrosse clock?
Press and hold the SET button for 3+ seconds to activate the manual mode. Once the clock is in manual mode, there are two ways to move the minute hand forward. 2. Hold the SET button down to move the minute hand forward consistently.
Why does my radio controlled clock show the wrong time?
Try rotating the clock. Most radio-controlled clocks have an internal antenna that picks up the signal most effectively when it is facing directly towards or away from Anthorn. Some clocks have a signal strength indication that helps in finding the best reception. Try moving your clock to a different location.
How do you set the time on a precision radio controlled clock?
TO SET THE TIME MANUALLY Press and hold the M. SET (2) button for 3 seconds to set the time: – Press the M. SET button (2) for 1 second to advance 1 minute – Press the M.
Why is my atomic clock not working?
Try powering down the clock (unplug it or remove the batteries), then turn it on again to see if it synchronizes. If the clock uses batteries, check them and replace if necessary. If the radio controlled clock is a desk top unit, try rotating it 90 degrees.
Why is my radio controlled clock not working?