Is Tear-Aid good?
Overall, we find Tear-Aid to be among the finest in its class, with only a few competitors in the same league. If you purchase Tear-Aid for a tough repair job, we’re certain the majority of consumers will be satisfied with its performance.
What is the difference between Tear-Aid Type A and B?
There are two Tear-Aid products that you will want to include in your boat. The Type A kit is for canvas, rubber, fiberglass, and plastic materials that are generally dry and do not contain oily substances. The Type B kit is used for quick repairs of vinyl materials that have oils.
What is Tear-Aid made of?
Each TEAR-AID Repair Patch is made from an exceptionally tough, matte finish, abrasion resistant, elastomer that resists puncture and tearing. It is combined with an aggressive adhesive formulated for high bond strength.
How long does Tear-Aid take to cure?
24 hours
Even though it takes 24 hours to cure, the adhesive was instant. As long as you prepare the surface as instructed, make sure all edges are rounded, it adheres perfectly. Immediately after applying none of the edges raised up or became unstuck.
How do you remove tear aid Type B?
Clean the repair surface with an alcohol prep pad or rubbing alcohol. When the area is dry, just peel the backing off the Tear-Aid patch and stick it on.
Is Tear-Aid washable?
Only wash over the polyurethane side and avoid getting the adhesive side wet. You cannot get the adhesive side of the patch wet or the patch can lift off.
Can you use a rubber patch on vinyl?
Because the formula and strength cannot be easily determined, using rubber cement to repair vinyl is not recommended. The solvents present in rubber cement may adversely react with vinyl and cause the vinyl to dissolve.
Is tear aid washable?
Does tear aid work on PVC?
Type A Tear Aid is not recommended for Vinyl or PVC.
Does Tear-Aid work on leather?
Tear-Aid Type A is applied to Canvas, Rubber, Neoprene, Nylon, Most Fabrics, Plastics, Sunbrella, Gortex, Polyethylene, Polypropylene, Polyurethane, Non-oiled Leather, Acrylics, Fiberglass, Aluminum, Polyester, Hypalon, Dacron… (Do not apply Type A to vinyl).