What is a Schlage reset only key?

What is a Schlage reset only key?

Reset keys are light blue in color to distinguish them from operating keys. The user must obtain a new set of Schlage five-pin keys cut to factory depth/space specifications. Cuts of the new keys must be duplicated onto an uncut Reset blank.

Can you reset all the on a Schlage door lock?

Press and hold the outside Schlage button. While holding the Schlage button, reconnect the batteries and release the button afterward. This will reset the lock. To confirm if the reset is successful, press the outside Schlage button, then enter one of the preset User Codes (4-digit code).

How do you reset a Schlage door?

How to Reset the Schlage Touch (FE695 and BE375) Locks

  1. Disconnect the battery.
  2. Press and release the Schlage button on the outside of the lock.
  3. The following steps must occur within 10 seconds: Reconnect the battery terminal.
  4. Confirm the lock has been reset by opening the lock with one of the default User Codes.

How do you rekey a Schlage lock with a reset key?

Re-keying

  1. Locate and insert BLUE re set, key (Figure A & B)
  2. Rotate to 11:00 position.
  3. Remove reset key (Figure C)
  4. Install New Different reset key that you are re keying to (Figure D)
  5. Return to 12:00 position (Figure E)
  6. Remove BLUE re set key.
  7. Insert new operating key that matches the BLUE reset key you just used.

Can you rekey a Schlage lock without the key?

Re-keying a Schlage without a key is difficult because the locks were purposely designed not to be easy. A locksmith could do this quickly, but may be expensive since they will need to do a house call without a key. New Schlage locks come with a reset key that allows you to re-key the lock without other existing keys.

How do you reprogram a Schlage keypad lock?

Press the “Schlage” and then the “3” keys. When three orange flashes and three beeps occur, enter a new six-digit code. When three orange flashes and three beeps occur again, reenter the same new six-digit code. When light turns green, the new program code has been entered.

How do I reset my digital door lock?

1 Factory Reset

  1. Open your door.
  2. Extend the latch bolt.
  3. Slide up the cover to open the back of your lock, exposing the buttons beneath.
  4. Push and hold the reset button for 10 seconds, until the lock beeps.
  5. The light ring will flash red, then spin amber.
  6. The lock has now been restored and is ready to be set up again.

How do you rekey a lock if you lost the key?

Yes, it is possible for you to rekey a lock without the original key. A locksmith can change your locks even if you have lost or misplaced the original key. In general, it is possible to pick or shim the lock and unlock the door. Then, the locksmith will have a much easier time removing the lock cylinder.