How do I fix Windows XP Blue Screen Unmountable boot volume?

Unmountable boot volume in Windows XP

  1. To resolve this issue, boot into the Recovery Console.
  2. In the Recovery Console, type chkdsk /p to check to see if the disk drive is bad or marked as dirty.
  3. If, after performing this check it cannot locating anything wrong with the hard drive, reboot the computer.

What causes Unmountable boot volume?

The “Unmountable Boot Volume” error message occurs due to a variety of reasons. It can be due to a damaged file system and cannot be mounted, or the basic input/output system (BIOS) settings are configured to force the faster UDMA modes.

What does Unmountable boot volume mean?

The “boot volume” is the partition of the hard drive where boot files and Windows system are stored. If you get the “Unmountable boot volume” error, you won’t be able to get into Windows and will be stuck in a blue screen (BSoD) error.

How do I fix an unbootable laptop?

How to fix no bootable device on Windows 11/10/8/7?

  1. Method 1. Remove and connect back all hardware components.
  2. Method 2. Check boot order.
  3. Method 3. Reset primary partition as active.
  4. Method 4. Check internal hard disk status.
  5. Method 5. Fix boot information (BCD and MBR)
  6. Method 6. Recover deleted boot partition.

What does ‘unmountable boot volume’ mean?

What does ‘unmountable boot volume’ mean? An unmountable boot volume in Windows is caused by either a corrupt boot.ini that cannot find the bootable drive or a corrupt or bad hard drive that is unable to boot. Below are the steps you can follow to help solve or determine the cause of this problem.

How to fix unmountable boot volume stop error 0x000000ed?

– Navigate to the Advanced Settings screen by following steps 1 through 4 in Method 1. – In the Advanced Settings screen, click Command Prompt to activate the Windows Command Prompt console. – From the command line, type the following commands in order, and then press Enter.

How to perform clean boot in Windows XP?

– On the Services tab of System Configuration, select Hide all Microsoft services, and then select Disable all. – On the Startup tab of System Configuration, select Open Task Manager. – Under Startup in Task Manager, for each startup item, select the item and then select Disable. – Close Task Manager. – On the Startup tab of System Configuration, select OK .

How to fix Windows XP boot problem?

Boot from a standard Windows XP Install CD (not a Network Install CD).

  • At the first setup screen,hit R to repair Windows using the Recovery Console.
  • Select the Windows installation that you would like to repair by entering its number,followed by Enter.
  • At the Recovery Console,type each following commands followed by Enter: CD