How do I reset my Cisco 1142 to factory settings?
Step 1 Disconnect power from access point. Step 2 Press and hold MODE button while you reconnect power to the access point. Step 3 Hold the MODE button until the status LED turns amber, and release the button.
How do I reset my Cisco 1242 to factory settings?
Factory Reset via MODE Button Press and hold the MODE button while you reconnect power to the access point. Hold the MODE button until the Status LED turns amber (approximately 1 to 2 seconds), and release the button.
What is the default username and password for Cisco AP?
The default username is Cisco. Step 4 Enter the wireless device password in the Password field and press Enter. The default password is Cisco.
How do I reset my Cisco 1800 series router?
How to Factory Reset 1800 series Cisco router
- Connect you PC to the router via console cable and connect using Putty.
- Boot the router while holding ctrl and break get into rommon1>
- Type the following command.
- Type Reset to start the factory reset.
- To enter config mode, issue the config terminal command.
How do I reset a Cisco router to factory default settings?
Issue the write memory command in enable mode to overwrite the existing start-up configuration with the current running configuration. Reload the router with the reload command in enable mode. Once the router reloads, the System configuration Dialog appears. The router is now reset to the original factory defaults.
How do I change the start-up configuration of a Cisco router?
Method 1. 1 Check the configuration register on the router by issuing the show version command. 2 Erase the current start-up configuration on the router with the write erase command. 3 Reload the router with the reload command. When prompted to save the configuration, DO NOT save. router# reload System configuration has been modified.
How do I Reset my access point to factory default settings?
Step 1: Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point. Step 2: Press and hold the MODE button while you reconnect power to the access point. Step 3: Hold the MODE button until the Status LED turns amber (approximately 10 to 12 seconds), and release the Button.
How do I reset an aircap3502e?
Hello ivadministrator, To reset a AirCap3502E, hold down the mode button for 30 seconds at power on. Link below points to a Getting started for a 3500 series access point.