How do I reset my Sunbeam electric blanket controller?

How do I reset my Sunbeam electric blanket controller?

Unplug the power cord from the wall outlet. Check that the control is tightly connected to the module in the blanket. Re-plug the power cord into the wall outlet. On a digital control, you should see flashing symbols and the display on your control will clear.

How do you use a Sunbeam electric blanket controller?

Make sure the control cord is connected to the module and then plug the power cord into an outlet. Turn on your heated product, then turn the control to the highest setting and wait 5 to 7 minutes. Put your hand between the folds and you should feel the blanket/ mattress pad/throw warming up.

What are the settings on an electric blanket?

Your electric blanket will have several heating temperatures that are easily adjustable. Temperatures usually range from a low setting, a medium setting, and a high setting. If you are layering, you may want to start off with the lower setting to prevent you getting too hot in the middle of the night.

Why do my heated blankets stop working?

Check that the electric blanket cord is firmly attached to the blanket. Pull the plug out of the blanket attachment and look to see if any dirt or debris has gotten into the plug or on the cord that plugs into the blanket. Reinsert the cord into the blanket attachment.

Do Sunbeam heated blankets turn off automatically?

Controls with the “Auto-Off Select” feature have the “Auto-Off” active as the default so the heated product will automatically turn off after 10 hours.

Why does my electric blanket have two controls?

Combing Through the Controls Certain heated blankets feature dual controls that allow two people to sleep with different settings under the same blanket, while others have just one control that allow you to preheat or adjust your blanket.

Why is heated blanket blinking?

“FF” is Flashing on the Display If the sign “FF” is flashing on your digital control or if there is blinking light on your gradient control, that means there is a problem with your blanket and it needs to be reset. To do this, first unplug your product.

How do you set up a Sunbeam electric blanket?

Sunbeam Electric Blanket Operating Instructions

  1. Lay the electric blanket on your bed.
  2. Connect the cord to the module at the bottom of the blanket, near the label.
  3. Run the cord along the floor under the bed.
  4. Place the warming control on either side of the bed, near the headboard.
  5. Plug your blanket into the outlet.

How do you fix an electric blanket control?

– Verify that the blanket is NOT plugged in. – Spread the blanket out on a flat surface and identify where the electric components are. – Cut a small hole around the cord entry point on the blanket. – Cut off the main cord. – Cut the wires and remove as much as you can from the blanket.

Why is my Sunbeam Electric Blanket controller blinking?

– Make certain you have the power cord plugged firmly into the wall outlet. – Unplug the heating pad power cord from the outlet. – Open the control unit using a screwdriver. – Clean out the control unit on the cord. – Tighten any loose part in the control unit with a screwdriver.

How to reset a Sunbeam Electric Blanket?

– While still damp, gently stretch the blanket/mattress pad/throw back to its original size. – Drape the heated product over a clothesline or hang over a shower rod. DO NOT use clothespins. – Heated product must be COMPLETELY dry before reconnecting the power plug or control plug.

How to troubleshoot Sunbeam Electric blankets?

– Unplug Sunbeam Heated Blanket – Check that the control cord is connected to the module. – Plug the blanket back in and turn it “on.” – If that does not fix the problem, contact Sunbeam.