Is desoldering pump a soldering tool?
A desoldering pump is a mechanical device popularized as a solder sucker. This tool is used for removing the solder from a printed circuit board. You can find it in a convenient design comprising a trigger, a head, and an unlock button.
Do you need a pump to desolder?
To salvage or replace electronic components, you need to desolder the connections where they are attached to the circuit board. A desoldering pump and a desoldering braid should be fine for most DIY projects, and easily within a hobbyist’s budget.
How do you clean a solder pump?
Stick the tip of a clean cotton swab into the bottle of alcohol to saturate it. Use the saturated cotton swab to wipe out the barrel of the pump. Insert the damp cotton swab into the barrel of the desoldering pump and wipe it all the way around the inside to clean it.
What is the difference between soldering and desoldering?
Desoldering is the process of removing solder from a connection to allow for component changes or repairs. Soldering is the process of creating a permanent electrical connection between two or more components by melting and flowing solder to make the joint.
What is the process of desoldering?
Desoldering is the process of melting the solder and removing the joints made between two materials. In electronics, it refers to the removal of electrical components from PCB for troubleshooting, repairing, replacing, and salvaging. Desoldering is most commonly used for this purpose.
What can I use instead of a solder wick?
One night while i was doing some electronics repair i found out that i run out of solder wick, because i don’t use it that much i didn’t care to have extra of it, so i grabbed a piece of copper wire, i smeared it with some flux and i use it as a solder wick and it worked like a charm.
What is soldering wick for?
Desoldering braid or “wick” is a pre-fluxed copper braid that is used to remove solder, which allows components to be replaced and excess solder (e.g. bridging) to be removed.
How do you unclog a desoldering pump?
What removes impurities and cleans the surface before soldering?
Flux is used in both manual hand soldering as well as the different automated processes used by PCB contract manufacturers. The main purpose of the flux is to prepare the metal surfaces for soldering by cleaning and removing any oxides and impurities.