What is OOOOa?
NSPS OOOOa—Standards of Performance for Crude Oil and Natural Gas Facilities for which Construction, Modification or Reconstruction Commenced After September 18, 2015 [40 CFR 60, Subpart OOOOa] is a new source performance standard that effects new, modified, or reconstructed facilities and sources in the crude oil and …
What is an affected source?
Affected source, for the purposes of this part, means the collection of equipment, activities, or both within a single contiguous area and under common control that is included in a section 112 source category or subcategory for which a section 112(d) standard or other relevant standard is established pursuant to …
What is relative accuracy test Audit?
Relative Accuracy Audit means an alternative relative accuracy test procedure outlined in 40 CFR 60, Appendix F, which is used to correlate continuous emission monitoring system data to simultaneously collected reference method test data, as outlined in 40 CFR Part 60, Appendix A, using no fewer than three reference …
How do you reference 40 CFR?
Use § symbol when referring to the CFR text. Otherwise, when used with CAA or State regulations, spell out “section.” Do not capitalize it unless it’s the beginning of a sentence. Note: Do not use 40 CFR § 52.12 — it should be either §52.12, or 40 CFR 52.12. “Federal” should always be capitalized.
What is RATA test?
Relative Accuracy Test Audits (RATA) compares data from a facility’s Continuous Emissions Monitor System (CEMS) to a simultaneously collected reference method test data in order to assess the accuracy of the CEMS readings.
What is a rata EPA?
A RATA test is used to determine the accuracy of an installed CEMS and/or Flow Monitoring system. If the testing passes, then all recorded data is considered “Valid” for reporting emissions to the EPA. If the system fails the testing, then the data is “NOT Valid” for reporting.
How do you cite CFR?
Regulations are first published in the Federal Register and later appear in the Code of Federal Regulations (C.F.R.). A typical citation to the CFR begins with the title number, followed by the abbreviated reference __C.F.R. __ followed by the section and the year.
How do you cite EPA regulations?
Name, Title number Source § xxx (Year)….The Rules for Federal Regulations: I. The Code of Federal Regulations
- Name of the regulation. Start the reference with the name of the regulation if the regulation is commonly identified by its name.
- Title number.
- Abbreviated name of the source.
- Section number.
- Date.
What are the test methods in the 40 CFR Part 60 appendix?
The test methods in this appendix are referred to in § 60.8 (Performance Tests) and § 60.11 (Compliance With Standards and Maintenance Requirements) of 40 CFR part 60, subpart A (General Provisions). Specific uses of these test methods are described in the standards of performance contained in the subparts, beginning with Subpart D.
What does 40 CFR Part 68 stand for?
General Guidance on Risk Management Programs for Chemical Accident Prevention (40 CFR Part 68) – APPENDIX A: 40 CFR PART 68 – CHEMICAL ACCIDENT PREVENTION PROVISIONS (April 2004) Author US EPA, OSWER, Office of Emergency Management Subject This appendix contains the full text of 40 Code of Federal Regulations (CFR) Part 68.
What is 40 CFR Part 60 section 25E?
Method 25E – Determination of Vapor Phase Organic Concentration in Waste Samples The test methods in this appendix are referred to in § 60.8 (Performance Tests) and § 60.11 (Compliance With Standards and Maintenance Requirements) of 40 CFR part 60, subpart A (General Provisions).
How do I perform a statistical comparison for 40 CFR Part 60?
For the statistical comparison, use the relative accuracy analysis procedure in Performance Specification 2 of appendix B of 40 CFR part 60.