What is Timeguard used for?

What is Timeguard used for?

Timeguard is a well-established company that provides high-quality timing, lighting, safety and climate control products. They combine years of experience with practical design to deliver the energy savings that owners and occupiers are looking for.

How do you program a Timeguard?

Press and hold the Time button for 3 seconds, the word Hold will show on the screen. After 3 seconds release the Time button and the screen will show the year; Press the Time button repeatedly until the minutes are shown. Use Adv/Ovr or Boost to change the minutes to the correct value.

How do you set a Timeguard pin timer?

Insert a pin in the Outer Circle for an OFF period. The minimum switching interval is 30 minutes, and this can be increased in 15 minute steps. Set the correct time of day by rotating the dial clockwise until the correct time is indicated by the Time indicator at the top centre of the time switch.

How do I reset my Timeguard?

To clear programmes from memory and reset the time controller press and hold down both buttons until the display goes blank. Release buttons and display will fill with its complete range of characters and then clear to show clock and hour digit flashing. This product has a factory fitted rechargeable battery.

How do you set a Timeguard thermostat?

To set/alter the time and date at any time, press and hold the Select button for 3 seconds. The display light will illuminate. The hour will to flash, use the Up/Down (+/-) arrow buttons to alter the hour and press the Select button once to confirm.

What is Timeguard fst77?

Timeguard’s new look Fused Spur Timeswitches with easy viewing display, optional 1 or 2 hour boost facility and automatic Summer/Winter time changeover. Clearly delivering the tried and trusted features you expect from the SupplyMaster range.

How do you use Timeguard plug?

Plug the time controller into a socket and switch socket ON if necessary. Plug your appliance into the time controller and switch the appliance ON. It is possible to manually override the programmed time by operating the override switch located in the bottom left hand corner of the plug-in timer.

How do you set a Greenbrook timer?

Press the Y button then use the + or – button to select the “down” icon on the right hand side of the display, press Y again to enter the countdown mode. 3. Use the + or – button to adjust the hours and press Y to confirm. minutes will flash.

Is it cheaper to put hot water on a timer?

The truth of the matter is this: yes, you will use a little more energy initially when getting the water back up to temperature. However, you will use far more energy over the course of time because you’ll be heating the cylinder for hours on hours when no one will be using the hot water.