What should my throttle position be?
It should be zero or a couple of degrees when you are not working. The gas pedal needs to be pressed very S-L-O-W-L-Y until the throttle is open. At wide open throttle, the percentage of throttle opening should gradually increase.
What should my absolute throttle position be at idle?
Plug the scan tool into the vehicle’s diagnostic connector, turn the key ON, and note the throttle opening reading. At idle is should be zero or a couple of degrees. Press down on the gas pedal very S-L-O-W-L-Y until the throttle is all the way open.
How do you adjust throttle position?
Loosen the throttle position sensor retaining screw with a Phillips-head screwdriver. Adjust the TPS by moving it back and forth until the voltage is between 4.0 and 5.5 volts. Hold the TPS in place and tighten the retaining screw with the Phillips-head screwdriver.
How do you adjust the throttle cable on a Polaris Sportsman?
Adjust throttle cable freeplay at the handlebar.
- Locate the throttle cable. adjuster at the handlebar.
- Squeeze the end of the rub- ber boot and slide it far. enough to expose the end of.
- Loosen the adjuster lock nut.
- Rotate the boot to turn the. adjuster until 1/16″ to 1/8″
- Tighten the lock nut.
- Squeeze the end of the rub-
What is the code for throttle position sensor?
The most common throttle position sensor code is the P0122 – Throttle Position Sensor/Switch A Circuit Low Input. It’s triggered when the ECU detects that the TPS circuit A is outputting a lower voltage than expected.
Can you adjust the idle on a throttle body?
Look on the sides of the throttle body until you locate a screw or a rubber casing that houses a screw. This screw is how you adjust your idle.
What is an ETC switch?
The switch in the throttle housing serves a different function depending on which model of ATV you have. It may be referred to as an ETC (electronic throttle control) or a TSS (throttle safety switch) – it may be open on throttle lever release or closed on throttle release (all depends on the model and how it’s wired).
How big is the throttle position sensor on a Polaris Ranger?
3 x 2.2 x 1.4 inches 3131705 3140173 FTVSE006 Would you like to tell us about a lower price? 3140173, 3131705 Throttle Position Sensor – 3 PIN – For Polaris Ranger Sportsman RZR500 570 800 US! .
How big is the throttle position sensor on the rzr500?
1.58 ounces 3 x 2.2 x 1.4 inches 3131705 3140173 FTVSE006 Would you like to tell us about a lower price? 3140173, 3131705 Throttle Position Sensor – 3 PIN – For Polaris Ranger Sportsman RZR500 570 800 US! . . . .
Where is the throttle position sensor (TPS) located?
The TPS is located on the passenger side of the throttle body. It tells the ECU how far open the butterfly in the throttle body is. If the TPS goes bad it can make the machine run erratically, or cause a hesitation at certain rpm’s.
How do I adjust the idle voltage on my Polaris Ranger?
If the voltage is outside of that range, turn the idle voltage adjustment screw on the left front of the throttle body ( directly above the throttle cable ) until you have the desired voltage. Although the screw is designed to require a special tool ( Polaris part # PU-47315 ), it can be done with needle nose pliers.