How do I enable IP routing on HP Procurve switch?

HP Procurve 2910 Switch (routing configuration)

1. login to the switch through TELNET OR SSH.
2. Standard configuration does not contain a password.
3. type configure terminal.
4. type a hostname “name of the switch”.
5. Type vlan 1 and configure an ip address.
6. Enter a default gateway.

How do I setup a static ip route?

Configuring Static Routes

1. Navigate to the Configuration > Network > IP > IP Routes page.
2. Click Add to add a static route to a destination network or host. Enter the destination IP address and network mask (255.255.
3. Click Done to add the entry. Note that the route has not yet been added to the routing table.

How do I find my ip route using CMD?

To display the local routing table:

1. Open a command prompt.
2. Type route print.
3. Press Enter.
4. Observe the active routes by destination, network mask, gateway, interface, and metric.
5. Close the command prompt to complete this activity.

What is switch IP routing?

Throughout this chapter, the switches are referred to as “routing switches.” When IP routing is enabled on your switch, it behaves just like any other IP router. Basic IP routing configuration consists of adding IP addresses, enabling IP routing, and enabling a route exchange protocol, such as RIP.

How do I view a route table in Windows?

Click Start, click Run, type cmd in the Open box, and then click OK. Type route print, and then press ENTER to view the routing table. Note the interface number of the network interface that you re-added. Type route print to verify that the new default route appears in the routing table.

How do I set a static route in CMD?

Add a Static Route to the Windows Routing Table You can use the following syntax:

1. route ADD destination_network MASK subnet_mask gateway_ip metric_cost.
2. route add 172.16.121.0 mask 255.255.255.0 10.231.3.1.
3. route -p add 172.16.121.0 mask 255.255.255.0 10.231.3.1.
4. route delete destination_network.
5. route delete 172.16.121.0.

What is route command in cmd?

The route command allows you to make manual entries into the network routing tables. The route command distinguishes between routes to hosts and routes to networks by interpreting the network address of the Destination variable, which can be specified either by symbolic name or numeric address.

How do I find the ip route in Windows?

Where can I find the hpprocurve routing switches?

www.hp.com/go/hpprocurve hpprocurve routing switches 9304m, 9308m, and 9315m (software release 7.5.X or greater) HP ProCurve Command Line Interface Reference

Where can I find the HP ProCurve command line interface reference?

hp procurve command line interface reference hpprocurve command line interface reference www.hp.com/go/hpprocurve hpprocurve routing switches 9304m, 9308m, and 9315m (software release 7.5.X or greater) HP ProCurve Command Line Interface Reference

How to set up HP ProCurve Networking?

HP Procurve Networking Setup Please follow & like us 🙂 HP Procurve Networking Initial Setup Note: HP Procurve Networking Configuration will be done via the CLI and assumes you have a console connection to the switch and are in configure mode. Enter configure mode by typeing configure. Setting a hostname

What are the HP ProCurve Networking advanced CLI commands?

HP Procurve Networking Advanced CLI Commands Reference This page will provide a subset of advanced Procurve CLI commands for easy reference. These include vlans, trunking, IP routing, spanning-tree, and more. This page will provide a subset of advanced Procurve CLI commands for easy reference.