What kind of wire should I use in my attic?
Wiring in the attic is typically a non-metallic cable (NM cable). It is allowed in most areas of the US, but not all. Make sure to double-check with the home builder. However, if it is in an existing home, check with your local professional electrician or home inspection company.
Does electrical wire in attic need to be in conduit?
No, conduit is NOT required in attics. Not unless conduit is required in your area. There are other factors involved in wiring in attic spaces, but your question is a bit too vague to go into that.
Can you run electrical wire through attic?
An attic can be a hazardous work space. New lighting, cable, computer networking and sound systems can all require wiring that may need to come through the ceiling. On a single-story home or the the upper floor of a multiple story home, this means accessing your attic to run wire.
Can I run an extension cord in my attic?
DON’T use extension cords to connect wires in the attic or above suspended ceilings/ANYWHERE. These are just accidents waiting to happen. A common violation is found in the installation of ceiling-mounted electrical equipment like projectors in training and meeting rooms (as in the following photo).
Can Romex be covered by insulation?
Romex can be installed above or under the insulation. It is OK to touch the outer jacket with your bare hands provided the insulation is not damaged. A good rule of thumb when working with electricity is to wear insulated (rubber sole) shoes and to always keep one hand in your pocket.
Can you lay insulation over electrical wires in attic?
It is perfectly safe for household insulation to touch wires provided the wires or cables are electrically insulated. There also are techniques to make insulation fit better around wires. However, under no circumstances should thermal insulation make contact with live uninsulated wires and cables.
Is it safe to run extension cord in attic?
Can insulation touch Romex?
Can you run Romex exposed in garage?
Exposed NM, NMC and NMS cable are allowed to be run in “one- and two-family dwellings, their attached or detached garages, and their storage buildings” by the National Electrical Code (NEC 334.10 and 334.15).
Is Romex allowed above drop ceiling?
Yes, Romex® NM cables can be used above a drop ceiling. As long as the cables are not exposed to damage and comply with building codes, it is safe to use Romex® brand NM cables above a drop ceiling. Dwelling or households approve Romex® brand NM cables, but places that allow access to drop ceiling cannot use it.
Do attics have outlets?
Yep, not only allowed, it is required if you have HVAC in the attic, very common here.
How often should you secure Romex?
How often should you secure Romex? General Cable Support Runs of NM cable must be supported at least every 54 inches . 1 They also must be secured within 12 inches of an electrical box that includes a cable clamp or within eight inches of a box or enclosure without a cable clamp.
What type of Romex should I use?
About 1/2 inch of outer cable sheathing should extend into the box past the cable clamp.
Can you leave Romex exposed in garages or basements?
The short answer to the question is – no, you should never expose your Romex wiring in your garage. You should always cover Romex wiring in your property. This article will give you more details about Romex wiring and the pros and cons of using the Romex wiring. How Do You Cover Exposed Romex? Can Romex be Exposed in Garage? 1. Very Light Weight 2.
Is Romex allowed in an unfinished garage?
Someone told me it is against NEC to have romex in assessable areas as in an unfinished garage.